Daily salinity fluctuation alleviates salt stress on seedlings of the mangrove Bruguiera gymnorhiza

Salinity is a vital factor that regulates leaf photosynthesis and growth of mangroves, and it frequently undergoes large seasonal and daily fluctuations creating a range of environments – oligohaline to hyperhaline. Here, we examined the hypotheses that mangroves benefit opportunistically from low salinity resulting from daily fluctuations and as such, mangroves under daily fluctuating salinity (FS) grow better than those under constant salinity (CS) conditions. We compared growth, salt accumulation, gas exchange, and chlorophyll fluorescence of leaves of mangrove Bruguiera gymnorhiza seedlings growing in freshwater (FW), CS (15 practical salinity units, PSU), and daily FS (0–30 PSU, average of 4.8 PSU) conditions. The traits of FS-treated leaves were measured in seedlings under 15 PSU. FS-treated seedlings had greater leaf biomass than those in other treatment groups. Moreover, leaf photosynthetic rate, capacity to regulate photoelectron uptake/transfer, and leaf succulence were significantly higher in FS than in CS treatment. However, leaf water-use efficiency showed the opposite trend. In addition to higher concentrations of Na⁺ and Cl⁻, FS-treated leaves accumulated more Ca²⁺ and K⁺. We concluded that daily FS can enhance water absorption, photosynthesis, and growth of leaves, as well as alter plant biomass allocation patterns, thereby positively affecting B. gymnorhiza. Mangroves that experience daily FS may increase their adaptability by reducing salt build-up and water deficits when their roots are temporally subjected to low salinity or FW and by absorbing sufficient amounts of Na⁺ and Cl⁻ for osmotic adjustment when their roots are subsequently exposed to saline water.     

多点液压式波浪能海水淡化系统建模与仿真

为缓解淡水资源短缺及化石能源过度使用问题,提出多点液压式波浪能海水淡化系统,该系统主要由采能装置、液压传递系统与反渗透膜海水淡化设备组成。系统的采能装置采用振荡浮子式,可将波浪能转换为浮子振荡从而被液压系统吸收达到采集波浪能的目的。为了提高液压式波浪能海水淡化系统的采能效率及淡水率,利用AMEsim软件对液压传递系统进行建模与仿真,分析了蓄能器、浮子个数及波高对液压传递系统输出响应的影响。结果表明:蓄能器能够使液压马达的输出响应更加稳定;当浮子的数量增加时,液压系统达到稳定的运行状态所需的时间更短,从而有利于提高系统的效率;波高在2 m左右时,本系统的产水量达到最大。     

福建大田—漳平地区构造-热对煤系石墨成矿及赋存的控制探讨

福建省大田—漳平地区位于东部滨太平洋构造带上，不同时期的岩浆热液作用和复杂多变的构造形变格局，为该地区形成丰富的石墨矿床提供了良好的成矿条件。为了查明大田—漳平地区煤系石墨的成矿控制因素及分布规律，通过工业分析、元素分析、X射线衍射和激光拉曼光谱等实验，对不同矿区不同变质程度的煤和煤成石墨的化学组成及微观结构特征等煤成石墨化特征进行了研究，并将不同变形特征的样品划分为煤成石墨、煤成半石墨和石墨化无烟煤三大类。研究表明:煤的变形特征与煤成石墨的演化类型基本一致，且韧性变形样品的石墨化程度最高，说明构造应力作用能促进煤的石墨化作用；煤成石墨的分布受到岩浆-构造活动的控制，石墨矿床多产出于岩浆岩侵入体外接触带或附近断裂带的有利围岩地层中，且大田—漳平地区煤系石墨矿具有明显的成区、成带分布特点，煤成石墨成矿区主要集中在闽西南坳陷南部的漳平一带；而北部大田一带分布的矿区矿体石墨化程度较漳平一带低，多为煤成半石墨或石墨化无烟煤，研究结果可为该地区煤系石墨矿产综合勘探开发利用提供有利依据。      

基于钻进状态监测的智能工况识别

钻进过程状态监测旨在实时描述钻进工况，判断运行性能优劣程度进行非优追溯，及时指导司钻人员调整作业操作,保证钻进过程安全、高效、稳定开展。钻进工况是钻进系统运行状态的反映，因此开展面向状态监测技术的钻进工况识别研究具有重要的理论和应用价值。本文针对钻进工况识别问题，基于状态监测数据，建立基于支持向量机的钻进工况识别模型，对钻进工况进行识别。综合工况识别结果，对钻进效率进行评估，并对影响钻进效率的因素进行讨论，寻找提升钻进效率的手段。最后，采用钻进现场实钻数据进行仿真实验,验证所提方法的可行性和有效性。     

Magnitude of latent heat in thermally loaded clays

Temperature changes are known to induce specific couplings in clay, in particular, an anomalously high thermal pressurization in undrained conditions or a thermal compaction in drained conditions, both of which are potential threats for the mechanical stability and sealing capacity of the geomaterials. Thermodynamical analysis of those peculiar thermomechanical couplings points to a potentially important latent energy, which in turn could limit the temperature change upon heating or cooling. The direct measurement of latent energy developed during a laboratory geomechanical test is challenging. Instead, proper identification of thermal hardening in conventional experiments with temperature changes provides an alternative route to estimate latent energy. In this work, existing laboratory thermomechanical tests of clays are analyzed with a rigorous thermodynamic framework to quantify the magnitude of latent energy in thermomechanically loaded clays. A thermodynamically consistent constitutive model for fully saturated clays that combines two key features, (a) the temperature dependence of the blocked energy and (b) the framework of bounding plasticity, is proposed. The performance of the model is validated by reproducing results obtained in laboratory tests for Boom and Opalinus clays. The thermomechanical loads considered to validate the model performance were then used to estimate the percentage of work that remains latent in the clayey material during plastic yielding. We find that the magnitude of latent energy is quite significant, typically a few tens of percent of the total dissipated energy, and increases significantly with temperature. Accordingly, it is expected to play an important role in the thermomechanical response of clays.     

敞开酸溶和偏硼酸锂碱熔ICP-MS法测定多金属矿中的稀土元素及铌钽锆铪

用电感耦合等离子体质谱法(ICP-MS)测定地质样品中的稀土及难熔元素,混合酸敞开酸溶法和碱熔融法是两种主要的溶样方法。但地质样品组分复杂,元素之间存在相互共生的现象,对于特殊元素、特殊样品用传统酸溶法会造成部分元素消解不完全,使测定结果不准确;而碱熔法的操作过程繁琐,且溶液盐度高,易产生基体干扰和堵塞仪器进样系统。本文改进了传统四酸和五酸体系,采用氢氟酸-硝酸-硫酸敞开酸溶体系,用国家一级标准物质制作标准曲线测定15种稀土元素,方法准确度(ΔlgC)为0.001～0.027。同时改进了偏硼酸锂碱熔法,样品用偏硼酸锂碱熔提取,加入氢氧化钠调节溶液至碱性条件,所测元素与偏硼酸锂共沉淀后过滤分离熔剂,再用硝酸复溶测定15种稀土元素及铌钽锆铪。两种溶样方法的测定值与认定值的相对误差为1.09%～9.30%。将混合酸敞开酸溶法测定稀土元素、偏硼酸锂碱熔法测定铌钽锆铪的结果与其他实验室密闭酸溶法相比,两组数据的相对偏差为0.13%～15.32%。本实验表明,混合酸敞开酸溶法适用于测定地质样品中的稀土元素,偏硼酸锂碱熔法不仅适用于测定地质样品中的稀土元素及铌钽锆铪,也适用于测定如古老高压变质岩石及铝含量高的样品中的铌钽锆铪。     

波纹钢管铅阻尼器耗能性能分析研究

提出一种波纹钢管铅阻尼器，介绍了其构造、工作机理、布置形式及特点，采用ABAQUS软件，建立钢管阻尼器、波纹钢管阻尼器和波纹钢管铅阻尼器有限元模型，对其应力分布，传力路径和滞回性能进行模拟分析。结果表明:波纹钢管铅阻尼器耗能减震机理明确，工作性能和耗能性能稳定，滞回曲线饱满以及耗能能力强，具有良好的变形和延性，极限变形大；波纹钢管铅阻尼器通过在波纹钢管内设置铅芯使初始刚度、承载能力和耗能能力得到大幅度提高，既有效保持了波纹钢管的变形能力，又避免波纹钢管发生局部屈曲，使波纹钢管耗能能力得到充分发挥。波纹钢管铅阻尼器在1mm小位移下就可以进入耗能，而且很快进入稳定耗能状态，等效阻尼比稳定在0.3~0.4之间。     

The evolution of the spatial-temporal patterns of global energy security since the 1990s

Journal of Geographical Sciences - In this study, we developed an energy security evaluation model (ESEM) from three dimensions, energy supply-transport security, safety of energy utilization, and...     

Experimental investigation on a cabin-suspended catamaran in terms of motion reduction and wave energy harvesting by means of a semi-active motion control system

A novel concept catamaran equipped with a suspended cabin, named Wave Harmonizer Type 4 (WHzer-4), is proposed and evaluated. The mass-spring-mass system is constructed by mounting four sets of suspensions in-between the cabin and the twin-hull. Two sets of dual motor/generators (M/Gs) are attached on the center beam of the cabin's deck fore and aft. Each shaft-end of the dual M/Gs is connected to the twin-hull through a rack-pinion gear unit. In this way the vertical relative motion between the cabin and the twin-hull can be transferred into the rotational motion of the M/Gs, and vice versa. A semi-active motion control system, which contains a proportional-integral (PI) controller, is designed and applied to each of the dual M/Gs for the aim of absorbing wave energy under the condition of suppressing the local vertical velocity of the cabin as much as possible. A 1/5 scale model ship with a length of 1.6 m is built, and a forced-oscillation bench test is implemented to validate the performance of the control system. Then, a series of towing tank tests is carried out in regular head waves. The heave and pitch responses of the cabin, those of the twin-hull and the corresponding wave energy capture width ratio (CWR) at five control scenarios and two reference scenarios are investigated. Discussion on the results of the tank test shows that the motion reduction of the cabin and the wave energy harvesting can be achieved simultaneously at a few wave conditions. However, at other conditions, although noticeable amount of wave energy is harvested, motion reduction of the heave and pitch of the cabin could not be obtained at the same time. It is suggested that varying the gain settings of the PI controllers according to the location of the controllers may improve the effectiveness of the proposed control system.     

多能互补海洋能集成发电技术研究综述

介绍了国内外基于风能、太阳能、波浪能和潮流能等海上可再生能源进行多能互补集成发电的研究发展情况,从不同技术研究侧重点、不同装置机理差异性和多能互补集成发电方式等方面进行了概括和综述,对已有设备和理论研究等进行了对比,评述了目前海洋多能互补集成发电技术研究中存在的主要问题以及未来的研究发展趋势,指出未来海洋能源集成发电需在离岸化、新材料、大型化和阵列布局等方面进行技术研究和攻关。